Editing Set64rs-Adaption-Of-MultiChannel-Software-Channelization


'-- glbNumberOfChannels = 64  '--for set64rs > maximum possible > below 32 is used because 32 is max for anafaze
    '-- any way to set N_Channel before the declarations below? > Use const
'-- glbChannelNumber = operational channel at any given time
'-- glbChannelMap( 1 to N_Channels ) = map of channel number versus modbus address: 1 - N_Channel , addr
'-- In operation the temperature components will use the same arrays
'-- the control timer executive will be modified to access more than one modbus address
    '-- anafaze > uses just 1 address and loads the entire arrays > array load happens in driver
    '-- set64rs > uses multiple addresses > each use of driver only loads 1 array element >
        '--thus requires multiple calls by the executive control timer loop -OR- a routine in the driver to fill the arrays > do there!