|
|
| (3 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
|
| |
| == Set64rs-Page-List == | | == Set64rs-Page-List == |
|
| |
|
| *[[List of set64rs need fix]] | | *[[List of set64rs need fix]] |
| | | *[[Set64rs-Adaption-Of-MultiChannel-Software-Channelization]] |
| | | *[[Set64rs-Channel-Management-Form]] |
| == Scanning Channel Installation Tool ==
| | *[[Profile-UpLoad-Form-Set64rs]] |
| | |
| *Assume a known fully installed serial port | |
| | |
| | |
| | |
| == DataBase Design ==
| |
| | |
| Fields = NAME START STOP CHAN# INSTALLED? .... all channels in just 1 database ????
| |
| | |
| == Address Setup ==
| |
| | |
| | |
| == Initialization Scan ==
| |
| | |
| *Do initial scan to see which controller addresses are installed | |
| *Stores status in the database table under INSTALLED? | |
| | |
| | |
| | |
| | |
| '''Manual Method'''
| |
| | |
| *User looks at database and selects address
| |
| *User can manual set / select controller modbus address using controller front panel
| |
| | |
| | |
| | |
| '''Automated Method where computer helps'''
| |
| | |
| | |
| *Prompt User > connect unit to be installed > disconnect all other controller communication cables
| |
| | |
| *Scan address 1 - 64 until unit is found > look for valid reply
| |
| | |
| *Check to see if this address is already used:
| |
| **Prompt User > This address is already in system use by NICKNAME | This address is not already in use
| |
| **Prompt User > You can Change address by clicking X Button. ( has textbox display and button pair + number only parsing ) > verify not already in use!
| |
| **If user changes address > rescan to verify change in effect > Prompt User > change effected
| |
| | |
| *Prompt User> Store this in channel database? Click Store Channel
| |