|
|
| Line 4: |
Line 4: |
| *[[Set64rs-Adaption-Of-MultiChannel-Software-Channelization]] | | *[[Set64rs-Adaption-Of-MultiChannel-Software-Channelization]] |
| *[[Set64rs-Channel-Management-Form]] | | *[[Set64rs-Channel-Management-Form]] |
|
| |
| == Scanning Channel Installation Tool ==
| |
|
| |
| *Assume a known fully installed serial port
| |
|
| |
|
| |
|
| |
| == DataBase Design ==
| |
|
| |
| Fields = NAME START STOP CHAN# INSTALLED? .... all channels in just 1 database ????
| |
|
| |
| == Address Setup ==
| |
|
| |
|
| |
| == Initialization Scan ==
| |
|
| |
| *Do initial scan to see which controller addresses are installed
| |
| *Stores status in the database table under INSTALLED?
| |
|
| |
|
| |
|
| |
|
| |
| '''Manual Method'''
| |
|
| |
| *User looks at database and selects address
| |
| *User can manual set / select controller modbus address using controller front panel
| |
|
| |
|
| |
|
| |
| '''Automated Method where computer helps'''
| |
|
| |
|
| |
| *Prompt User > connect unit to be installed > disconnect all other controller communication cables
| |
|
| |
| *Scan address 1 - 64 until unit is found > look for valid reply
| |
|
| |
| *Check to see if this address is already used:
| |
| **Prompt User > This address is already in system use by NICKNAME | This address is not already in use
| |
| **Prompt User > You can Change address by clicking X Button. ( has textbox display and button pair + number only parsing ) > verify not already in use!
| |
| **If user changes address > rescan to verify change in effect > Prompt User > change effected
| |
|
| |
| *Prompt User> Store this in channel database? Click Store Channel
| |