Temperature-Controller-Specification

Temperature Controller Specifications

Temperature controller specs

• Controller Type = PID

• Multiple input types: Must work with K type
  • good if works with following types also: R,S,K,J,T,E,RTD,L,U

• Temperature range with K thermocouple = 2300 deg F

• Prefer to be able to choose Fahrenheit or Celsius

• serial communications
  • prefer zascii over modbus
  • prefer model that has both RS-232 and RS-422 communications option

• Output Type:= SSR output drive pulse PWM on / off modulation

• dual display if possible

• write only to RAM unless I specify NVRAM when I set the desired temperature

• Form Factor: 1/16 or 1/4 DIN

Documentation needed

• 1- operation manual

• 2- communications protocol manual

Added desirables

• 1- 232 to 422 converter

Controller number generation

Chapter 2. Type and Designation －2－ AOB808 ① ② ③ ④ ⑤ ①Dimension code designation of the instrument panel A:96× mm D:96 72×72mm E:48×96mm F:96×48mm G:48×48mm H:160×80mm S:80×160mm ② ③ ④ ⑤ type of the module installed at OUT, 0 for no module installment type of the module installed at AL1, 0 for no module installment or no AL1 type of the module installed at AL2, 0 for no module installment or no AL2 type of the module installed at AUX, 0 for no module installment Note: the applicable module type for each part of the instrument can be selected according to instrument wiring instructions discussed in Chapter 7.