Set64RS-Temperature-Controller

Set64RS notes

Main Board

• CPU chip = 16F76-I/SO
  • RC6 / TX / CK > pin 17 - TX Goes to 485 circuit
  • RC7 / RX / DT > pin 18 - RX goes to 485 circuit
  • RA4 / T0CKI > pin 6 - TXEN goes to 485 circuit ( T0CKI = Timer 0 Clock input )

PIC chip > 193 bytes RAM / 4096 words of program memory

CD4051B - 8 channel mux / demux

74hc164

24LC64 > 64 kbit serial eeprom 9 ( 8 kbytes )

crystal frequency = 18.432 MHz > 1920X 9600 baud

Comments

• Why does the TXEN line go to the rs-485 circuit? direction control?

• • Naming convention **TXEN** is suspicious = Transmit Enable ?? > most likely
  • Most likely the 18.432 xtal is the timing oscillator for serial bus. 18.432 / 1920 = 9600 baud
  • Most likely the TXEN controls flow and RA4 is used as in input output pin for this and not to connect to timer0

Conclusions

• Most likely could setup a circuit using TXEN as flow control with TX and RX going to line receiver / transmitter.
  • would need to figure out TXEN states > HIGH is TX or RX enable??

• The comm protocol is more difficult as I have no example. I have addresses of registers but no examples.