Set64rs-start-a-profile-run

Profile-UpLoader-Video-Presentations

How to run a profile

Select the profile you want to run by clicking on the row in the profile log in which it is listed. It will be highlighted and the corresponding profile in CONTROLLER MEMORY will be highlighted. Then click on SELECT PROFILE. Click OK when you are warned that the high and low program pointers will be changed.

Click on start profile. At this point you will be prompted to enter the 8888 passcode using the front panel of your set64rs controller. The programmers of the firmware in this controller goofed. They did not provide a way to start a profile remotely using a computer. Instructions will pop up in the user prompt area to tell you how to do this. After you have punched in 8888 and clicked OK the controller will commence sequencing through your profile.

If you want to at this point you can click on the monitor and the RUN STATE will be updated every 15 seconds.